Concrete Sealing & Densifying in Atlanta
Who seals and densifies concrete in Atlanta? Cleanworx 360 applies densifiers and sealers that stop dusting and help commercial concrete resist stains, for warehouses, retail, garages and public buildings across metro Atlanta. Free floor walk-through. Call (470) 363-1191.
Why seal and densify concrete
Bare concrete is porous and softer at the surface than most people expect. Under traffic it slowly wears and gives off a fine powder that settles on shelving, products and equipment. Spills soak in and leave stains. Sealing and densifying fix both problems without the time and cost of a full coating system.
A densifier is a liquid that soaks into the slab and reacts with it, hardening the top layer from the inside so it stops dusting and wears more slowly. A sealer then fills or covers the surface pores so liquids bead up instead of soaking in, giving you time to clean up oil, drinks and chemicals before they stain.
Sealer options we use
The right product depends on traffic, spills and the look you want. We help you choose.
Penetrating densifiers
Silicate-based treatments that harden the slab and cut dusting. Invisible once cured, with no film to wear off.
Penetrating sealers
Repellents that sit in the pores to keep water and oil from soaking in, while keeping a natural concrete look.
Topical sealers
Acrylic or urethane films that add stain protection and a light sheen. Good for lower-traffic rooms and decorative concrete.
What is included
A typical sealing and densifying scope covers:
- Floor walk-through and a check for moisture and old sealers
- Deep cleaning and degreasing so the product can soak in
- Light grinding or etching where the surface needs opening
- Crack and joint filling where needed
- Sealer application and cure-time guidance
- Clear instructions for cleaning and re-sealing
Walk-through
We look at how the floor is used, test how it takes water and spot stains and damage.
Written scope
You get a written plan naming the products, prep and schedule.
Clean and prep
The slab is scrubbed, degreased and opened up so the treatment can penetrate.
Densify and seal
We apply the densifier, let it react, then apply the sealer you chose.
Cure and hand-back
We tell you when the floor can take foot and equipment traffic and how to care for it.
Warehouses & storage
Stops slab dust from coating stock, racking and equipment.
Makes stockrooms and receiving areas easier to keep clean.
Garages & shops
Keeps oil and fluids from soaking in while you clean them up.
Public buildings
Long-lasting protection for mechanical rooms and service corridors.
Low-dust slabs that help keep sensitive equipment clean.
Sealing, polishing or epoxy?
Sealing and densifying is the lightest-touch option: fast, affordable to maintain and good at stopping dust and stains. If you want a brighter, more finished look, polished concrete builds on the same densifying step and adds grinding and polishing. If you need color, a seamless surface or strong chemical resistance, an epoxy floor coating is the better fit. During the walk-through we will lay these out side by side so you can pick with confidence.
Keeping a sealed floor protected
Sealers wear down in the busiest lanes over time. Regular scrubbing with a neutral cleaner helps them last, and re-sealing traffic areas before they wear through keeps the slab protected. Cleanworx 360 can handle that schedule through a floor maintenance plan so you never have to think about it.
